HPI Bullet 3.0 MT/ST Front C-Hub Alloy Upgrade BMT019 by GPM  [BMT019]

Front C-Hub Replacement for Bullet 3.0 MT and ST

An aluminium alloy C-hub crafted for the HPI Bullet 3.0 MT and ST platforms, built to provide a dimensionally stable mounting point for front steering assemblies on nitro-powered short-course and monster truck style models.

The component is supplied as a direct replacement for the factory steering hub on compatible Bullet 3.0 MT and ST assemblies, retaining stock mounting geometry while offering a firmer contact surface for knuckles and tie-rods. Intended for model use only.

Fitting tips: install using the original mounting points and hardware where possible. Check local fastener condition, verify steering travel, and re-adjust toe and alignment after fitting to preserve safe handling characteristics.

Use this alloy C-hub when worn hubs need replacement or when tuning for a firmer steering mount on Bullet 3.0 MT and ST models.