This front adjustable tie rod fits HPI Bullet 3.0 MT and ST nitro chassis and is supplied as a matched pair. The rod uses spring steel for resilience while alloy end fittings protect connection threads; a 4mm anti cross-thread feature helps maintain clean engagement. Length can be set from 73mm up to 80mm to suit simple steering geometry changes.
In service the link controls toe and reduces play when replacing worn plastic parts. Its adjustable nature allows quick small changes to toe-in or toe-out so you can fine tune handling without swapping to a fixed link length.
Installation guidance: intended for RC-scale use on the listed HPI models. Thread parts carefully and verify the alloy ends sit correctly against the steering knuckle and bell crank. Set both sides to the same length and check tightness after first runs to ensure nothing loosens.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
