HPI Bullet 3.0 MT/ST Radio Bay Tray Graphite Blue GBMT014B by GPM  [GBMT014B]

Radio bay tray for Bullet 3.0 MT and ST installations

This graphite radio tray is offered as a direct-fit replacement for HPI Bullet 3.0 MT and ST models configured with Nitro power. It gives a secure platform to mount the receiver, servo and other small electronics while keeping wiring neat within the chassis layout used on these models.

The component is graphite with a blue coating and sits in the vehicle radio bay using the stock mounting pattern for Bullet 3.0 MT and ST. The design favours a stiff, low-profile panel that integrates with standard 1/10 off-road component placement rather than increasing chassis height.

Fitting notes: supplied as a single panel, it should be fixed through the chassis existing screw locations where they match. Follow the original routing for antenna and battery or power leads, and inspect clearance near the servo and fuel tank on Nitro variants before final assembly.

Practical use: keep radio hardware consistently located for setup and servicing, and make receiver or servo access faster during maintenance without affecting the main chassis geometry.