HPI Bullet 3.0 MT/ST Rear Beadlock Tire and Rim Pair BMT1003R+889 by GPM  [BMT1003R+889]

Rear tyre and beadlock assembly

This rear tyre and rim replacement kit is made for HPI Bullet 3.0 MT and ST nitro vehicles. It combines durable rubber tyres, nylon rim frames to keep weight down, and alloy 10-pole beadlock rings, and includes 12x9mm drive adapters for compatible hubs. Supplied as a single pair, the set is ideal for replacing worn rear wheels or fitting beadlock rims.

Intended use: these parts are designed as direct-fit spares and performance hop-ups to recover rear traction and secure tyre clamping. The nylon frames lower rotating mass while alloy beadlocks clamp the tyre bead mechanically. The 12x9mm adapters adapt the rim assembly to vehicles using that axle spec.

Installation tips: confirm axle and hub measurements and that your vehicle uses a 12x9mm drive interface. Install the rim assembly with the supplied adapters, tighten hardware to recommended torque, and verify bead seating and wheel runout. Re-check fasteners after the initial run.

Best used to replace worn rear wheels or to upgrade to beadlock mounting; always verify compatibility with your chassis before ordering.