HPI Bullet 3.0 MT/ST Steering Link Tie Rods 7pc BMT160ST by GPM  [BMT160ST]

Aftermarket steering links for HPI Bullet 3.0 MT and ST

This seven-piece tie rod pack is produced as an aftermarket replacement for HPI Bullet 3.0 MT and ST nitro models, focused on basic steering and suspension linkage duties. Spring steel rods paired with moulded plastic ends keep weight down while maintaining threaded adjustability and pivot retention.

Supplied as a matched set, these tie rods swap into common steering and suspension positions to recover original alignment and toe adjustability. They are intended for scale RC maintenance and do not alter the chassis layout or geometry.

Fitment advice: examine ball cups and threads for wear, swap out any damaged fittings prior to installation, and tune rod length to the factory settings. Work the steering and suspension through their range to check for binding after final assembly.

Ideal for replacing tired linkages to restore predictable steering; recheck alignment and cycle joints after fitting to ensure smooth operation.