HPI Bullet Alloy 14mm Wheel Hex Compatible with BULLET 3.0 MT/ST - BUL-18013-BK by Jazrider  [BUL-18013-BK]

HPI Bullet - Black Alloy 14mm Wheel Hex
Price:
NZD$11.95
Brand:
JAZRIDER
Model:
BUL-18013-BK
Condition:
Brand New
Available in shop
Write a review

Replacement 14mm Wheel Hex Details

The BUL-18013-BK is supplied as a black alloy 14mm wheel hex intended for HPI Bullet spare parts. It is cut to interface with BULLET 3.0 MT and BULLET 3.0 ST wheel hubs, offering a straightforward replacement option for worn or damaged hexes.

Typical installation involves removing the wheel and any hub locking hardware, sliding the hex onto the hub splines until it seats, and refitting the wheel fastener. Ensure the hub and wheel threads are correctly engaged to avoid loosening during use.

For long term durability, inspect the hex and mating splines for wear or corrosion at regular service intervals. Maintaining correct fastener torque and replacing parts showing excessive wear will help preserve handling and safety.

How resistant is this hex to wear and corrosion?

The black alloy construction gives a good balance of durability and resistance to typical RC use; however, exposure to moisture and grit accelerates wear, so keep components clean and lubricated where appropriate.

When should the hex be replaced?

Replace the hex if spline edges show rounding, if the wheel slips under load, or if there is noticeable wobble after correct installation. Regular inspection intervals depend on usage intensity.

Any care tips to extend service life?

Keep spline interfaces free of packed dirt, avoid over-tightening which can deform parts, and check for damage after hard impacts. Clean and inspect after wet or muddy runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved