HPI Bullet FLUX Black Alloy Steering Kit for Tightened Linkages - BUL-18002-BK by Jazrider  [BUL-18002-BK]

HPI Bullet FLUX - Black Alloy Steering Assembly Set w/Bearing
Price:
NZD$21.89
Brand:
JAZRIDER
Model:
BUL-18002-BK
Condition:
Brand New
Write a review

Strength and Fit for Bullet FLUX

This black alloy steering assembly with bearing is built as an RC-scale replacement tailored to HPI Bullet FLUX models. It replaces plastic components to tighten up linkage tolerances and provide a firmer steering connection to the chassis.

Specified as a direct steering option for Bullet FLUX vehicles, the set ships with black alloy steering pieces and the stated bearing to support pivot motion. The component is aimed at enhancing steering feedback and resisting wear during routine running and setup sessions.

Installation tips: Intended to swap into the matching stock steering positions on compatible Bullet FLUX frames, the set helps restore alignment and reduce play when correctly fitted. Inspect ball ends, linkages, and servo mounting during the changeover for best results.

How does the alloy option affect longevity?

Alloy parts typically withstand abrasion and deformation better than plastic, so you should expect improved service life under normal hobby use compared with the original plastic pieces.

Is any special care required for the bearing?

Periodic inspection and light cleaning are recommended to keep the bearing free of grit. Avoid over-lubricating if the bearing is sealed, and replace it if play appears over time.

Will the alloy set need different fasteners?

The set is intended to use the same mounting points; however, check that existing screws and nuts are in good condition and replace any that show wear to ensure secure installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved