HPI Bullet FLUX Orange Alloy Steering Assembly BUL-18002-OR - Upgrade for Steering by Jazrider  [BUL-18002-OR]

Stiffer Steering Assembly for Bullet FLUX

This orange-finished alloy steering set is made for the HPI Bullet FLUX chassis to replace fragile plastic knuckles. Bearings are integrated to lower steering lash and offer a firmer linkage response. It is positioned as a chassis-level upgrade that improves steering precision without altering drivetrain output.

Installation tips

• Remove the stock steering knuckles on Bullet FLUX MT or ST and fit the alloy replacement in the factory mounting points.
• Where practical, retain factory fasteners but check that the servo horn and tie-rod clearances are correct before locking hardware down.
• Once installed, centre the steering and recheck toe and travel limits to ensure predictable handling.

Role in tuning

• Alloy knuckles with bearing support lower play at the pivot, improving repeatable steering inputs for precise track setup.
• Combine this upgrade with measured linkage geometry tweaks and suitable servo adjustment to tune response and stability.