HPI Bullet Front Alloy Chassis Reinforcement BUL-18004-BK by Jazrider  [BUL-18004-BK]

HPI Bullet - Black Alloy Front Chassis Brace
Price:
NZD$17.51
Brand:
JAZRIDER
Model:
BUL-18004-BK
Condition:
Brand New
Write a review

Reinforced front brace for HPI Bullet models

Made from black alloy, this front chassis brace is a direct replacement for HPI Bullet vehicles. It fits the front segment of the Bullet 3.0 MT and ST (Nitro Engines) chassis to increase rigidity where the front bulkhead meets the chassis.

The part is intended to improve chassis durability and to act as a tuning aid rather than as a cosmetic upgrade. Its alloy construction delivers a more rigid mounting plane for front components and helps limit chassis flex during hard driving.

Installation follows standard maintenance practice: access the factory mounting points or remove the stock brace, align the alloy brace with existing holes, and use OEM fasteners if they are compatible. Confirm clearance and operation of steering and engine components before finishing the installation.

Will this brace increase chassis longevity?

Yes. The alloy brace reduces stress on the front bulkhead junction, which can help slow wear and deformation from repeated impacts or heavy use.

Is the alloy finish corrosion resistant?

The brace uses a durable black alloy finish that resists typical environmental exposure. Regular maintenance and inspection are recommended after wet or salty conditions.

Will it survive track impacts?

The alloy improves stiffness and impact tolerance versus stock plastic braces, but severe collisions can still damage components. Inspect mounts after heavy impacts and replace if bent.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved