HPI Bullet Front C Hub Carrier (Bullet 3.0) Orange Anodized - BUL-18001-OR by Jazrider  [BUL-18001-OR]

Overview of the front C hub for Bullet 3.0

This front C hub carrier is an alloy replacement crafted for HPI Bullet platforms, finished in orange anodize. It functions as the interface between the steering knuckle and the front suspension upright, intended for BULLET 3.0 MT and ST variants with nitro engines.

Construction and finish: the part uses alloy material with an orange anodized surface to guard against wear where hinge pins and ball studs contact the carrier. The alloy surface gives a firmer mount than many stock plastics, helping reduce distortion that can affect steering precision.

Compatibility notes: designed to match the front suspension geometry of Bullet 3.0 MT and ST models. When the chassis shares the HPI C hub mounting pattern, the carrier accepts the stock hinge pins, ball studs and link locations as a direct swap.

Fitting guidance: remove the original C hub and transfer over bearings, hexes, hinge pins and steering hardware. After installation check steering throw and wheel alignment, and confirm there is no binding through suspension travel. Using a more rigid carrier can make tuning toe and caster adjustments react more predictably.

Contents supplied depend on the vendor; verify what is included prior to installation.