JAZRIDER BUL-18000-GU Alloy Front Knuckles HPI Bullet Upgrade  [BUL-18000-GU]

HPI Bullet - Gunmetal Alloy Front Knuckle Arms
Price:
NZD$18.52
Brand:
JAZRIDER
Model:
BUL-18000-GU
Condition:
Brand New
Write a review

Precision Alloy Knuckles for Bullet

The JAZRIDER BUL-18000-GU gunmetal alloy front knuckle arms upgrade steering precision for HPI Bullet users seeking a more solid feel. They are intended to perform reliably under the stresses common to nitro running.

Built for Tough Conditions

These knuckles use a gunmetal alloy that holds up better than stock plastic parts when exposed to impacts and heat. The increased rigidity helps the truck track truer at speed and under load.

Exact HPI Bullet Compatibility

Designed for easy swap-in on HPI Bullet 3.0 MT and ST variants, these knuckles fit with standard fasteners and require only basic tools to install. They suit both competitive and recreational drivers.

Can I use these on older Bullet chassis?

They are matched to the geometry of the 3.0 MT and ST Bullet layouts. Older chassis can sometimes accept them but may require checking steering link lengths and mount points.

Do these knuckles need special tools to fit?

No special tools are needed beyond the usual hex drivers and a wrench. Follow the vehicle torque settings and check running clearance after fitting.

Will these change steering feel on road and off road?

Expect firmer, more direct steering with less compliance. That benefits both loose-surface driving and high speed runs, though minor setup tweaks may be needed.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved