HPI Bullet Gunmetal Front Brace - BUL-18004-GU, compatible with Bullet 3.0 MT and ST by Jazrider  [BUL-18004-GU]

Gunmetal front brace for Bullet nitro models

This RC-scale front chassis brace is produced for the HPI Bullet series and listed as model BUL-18004-GU by JAZRIDER. The gunmetal alloy design focuses stiffness into the front section to assist with driver setup and balance tuning.

The component fastens at the original front chassis attachment points and integrates with the Bullet 3.0 MT and ST nitro chassis layout while preserving the stock geometry. Its function in tuning is precise: altering front stiffness to refine turn-in behavior and front traction across setup changes.

Fitment advice: confirm that your chassis mounting points match the listed Bullet variants before attempting installation. Use this brace as a structural hop-up for tuning rather than a full chassis swap.