HPI Bullet C Hub Carrier Upgrade Black Alloy - BUL-18001-BK by Jazrider  [BUL-18001-BK]

HPI Bullet - Black Alloy Front C Hub Carrier
Price:
NZD$17.52
Brand:
JAZRIDER
Model:
BUL-18001-BK
Condition:
Brand New
Write a review

Front C Hub Carrier Summary

This front C hub carrier is supplied as an aftermarket replacement for HPI Bullet vehicles listed as BULLET 3.0 MT and ST (Nitro Engines). The piece is a black alloy front C hub carrier that secures the steering knuckle and links the wheel hub to the vehicle's suspension and steering linkage.

For setup and tuning it provides the fixed mounting points for the hub and steering components, so it influences wheel alignment and bearing preload as well as steering feedback. Use factory or appropriate replacement fasteners, check clearances before full use, and standard hand tools like hex drivers are typically used to change C hub carriers.

How durable is the alloy construction?

The carrier is made from a black alloy material intended for replacement use; it offers improved strength over typical molded parts but actual longevity depends on driving conditions and impacts.

Can I reuse stock bearings and hubs?

In most cases stock bearings and hubs can be fitted, but check bore dimensions and clearance. Verify fitment on your BULLET 3.0 MT or ST chassis before final assembly.

Does the black finish resist corrosion?

The listing specifies a black alloy finish. Surface resistance varies by coating; keep parts clean and dry to extend service life.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved