HPI Bullet Rear Chassis Brace Upgrade, Gunmetal Alloy - BUL-18008-GU compatible with Bullet 3.0 MT/ST by Jazrider  [BUL-18008-GU]

HPI Bullet - Gunmetal Alloy Rear Chassis Brace
Price:
NZD$19.45
Brand:
JAZRIDER
Model:
BUL-18008-GU
Condition:
Brand New
Write a review

Stiffening brace for Bullet 3.0 MT/ST rear

This rear chassis brace is an RC-scale replacement component created for HPI Bullet platforms and produced by JAZRIDER under model BUL-18008-GU. The part is cast in gunmetal alloy and intended to strengthen the rear chassis area on Bullet 3.0 MT and ST nitro variants.

From a durability perspective the brace reduces flex that can accelerate wear on chassis mounts. It is a structural reinforcement mounted to the factory rear points, not an electronic or drivetrain upgrade.

Installation guidance: confirm the brace clears exhaust routing and the fuel tank on nitro setups and align it with the rear bulkhead fasteners. Consider thread locker for metal fasteners and re-evaluate chassis geometry after fitting to account for the stiffer rear section.

Is the gunmetal alloy suitable for heavy off-road use?

Yes. The gunmetal alloy construction of model BUL-18008-GU is aimed at resisting deformation and reducing fatigue under nitro off-road stresses on HPI Bullet 3.0 MT and ST rear mounts.

Will this part prevent mounting point wear?

The brace stiffens the rear section, which helps distribute loads and can slow wear at factory mounting points; it does not replace damaged bulkheads or chassis posts.

Any special maintenance after fitting?

Inspect fasteners and surrounding chassis for stress after initial runs. Re-torque metal fasteners if necessary and check for any new contact with exhaust or fuel plumbing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved