HPI Bullet Rear Chassis Reinforcement for BULLET 3.0 MT/ST - BUL-18008-BK by Jazrider  [BUL-18008-BK]

Reinforcement panel for BULLET 3.0

This alloy rear chassis brace is an RC-scale replacement engineered for HPI Bullet models. It provides a direct rear reinforcement that targets the back of the chassis to limit flex when under load or during rough off-road use.

Finished in black, the alloy construction strengthens the rear mounting area for suspension components and related hardware. It is compatible with BULLET 3.0 MT and ST variants in the HPI Bullet series; check your model code before ordering.

Installation is straightforward for those used to hop-up parts, attaching to the existing rear chassis mounting points via the factory holes. You will normally need a hex driver sized to your vehicle hardware and basic hand tools, and a suspension re-check after fitment is recommended.