HPI Bullet Rear Hub Carrier Upgrade for BULLET 3.0 MT and ST - BUL-18009-OR by Jazrider  [BUL-18009-OR]

Rear Carrier Details and Fitment

The BUL-18009-OR is an aluminium rear hub carrier created to match the HPI Bullet wheel and suspension geometry for BULLET 3.0 MT and ST variants. It replaces the factory plastic carrier to provide a stiffer rear mounting point while retaining original chassis alignment.

Material and role: constructed from orange alloy, the carrier secures the wheel hub and transmits suspension loads. Its increased stiffness changes how the rear responds under drive, braking, and cornering loads, giving a noticeable but controlled shift in feedback versus stock components.

Installation notes: it fits into the same location as the original rear carrier and uses the Bullet 3.0's existing bearings and screws. Ensure bearings seat correctly and that the wheel hex lines up with the driveshaft; torque fasteners to the manufacturer's spec and check for binding after installation.

Tuning considerations: alloy carriers reduce local flex and can alter camber/toe behavior under load. Revisit shock preload, arm geometry, and bearing play to fine-tune handling after fitting this part.