HPI Bullet Replacement Front C Hub Carrier for BULLET 3.0 MT and ST - BUL-18001-GU by Jazrider  [BUL-18001-GU]

HPI Bullet - Gunmetal Alloy Front C Hub Carrier
Price:
NZD$17.12
Brand:
JAZRIDER
Model:
BUL-18001-GU
Condition:
Brand New
Write a review

Bullet front C hub replacement

The BUL-18001-GU front C hub carrier is manufactured as a direct replacement for HPI Bullet 3.0 MT and ST chassis. Finished in gunmetal alloy, it serves as an upgrade or service part to keep the front suspension performing as intended.

Its role is to maintain correct front-end geometry and wheel alignment while allowing a swap in the original mounting footprint. Installation is performed by removing the front hubs and steering knuckles, installing the new carrier, then adjusting steering linkages and camber to factory specifications.

This carrier is suitable for repair jobs or for fine tuning the front suspension response on Bullet 3.0 MT/ST platforms without altering the chassis layout.

What tools are needed to fit this carrier?

Basic hand tools such as hex drivers and a small wrench set are typically sufficient to remove hubs and steering components and to fit the new carrier.

How long does installation take?

Expect a straightforward swap in roughly 20 to 40 minutes depending on experience and whether additional alignment checks are performed.

Are modifications required to fit?

No modifications should be necessary; the carrier is designed to use the model's existing mounting points and hardware.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved