HPI Savage 21 Alloy-7075 Steering Blocks Front/Rear Set SAV1021H by GPM  [SAV1021H]

Overview and Fitment Notes

This alloy steering block set is built for HPI Savage 21 scale vehicles as a direct upgrade to the factory plastic units. The kit replaces both front and rear blocks and arrives with the required screws and washers for a clean installation. Alloy-7075 construction prioritises stiffness and wear resistance while keeping factory mounting geometry.

Use these blocks to reduce unwanted hub flex during higher load driving or when refining suspension and steering geometry. The metal components provide a predictable load path from servo to wheel, helping with fine tuning of toe, camber and steering endpoints on mixed surfaces.

Hobbyists seeking reduced steering flex and stronger hub components will find this alloy set a practical upgrade for Savage 21 models, fitting into the existing hardware points for straightforward setup changes.