HPI Savage 21 Front Spring 1.6mm Wire for 115mm Shocks SAV13170/SP by GPM [SAV13170/SP]

HPI Savage 21 1.6mm Coil Spring F/115mm Long Damper - 1pr - GPM SAV13170/SP

Price:

NZD$4.36

Brand:

GPM

Model:

SAV13170/SP

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - HPI Racing - SAVAGE

Savage 21 front spring specification

Designed for HPI Savage 21 applications, this front coil spring features a 1.6mm wire diameter and is intended for use with 115mm long dampers. It is supplied as the listed component for shock replacement or spring swaps during suspension tuning on Savage 21 machines.

Installation is a standard shock service task: remove the shock from the car, take off the cap and shaft, slide out the old spring, fit the new coil onto the shock body or perch, then rebuild and check for correct travel and preload. Fine tune ride height and damping after fitting to confirm handling changes.

In tuning terms, the spring's wire size and compatibility with 115mm dampers provide a defined rate that helps when adjusting front support and balance on HPI Savage 21 models.

Can I use this spring on both sides without revalving?

Yes, you can fit matching springs to both front shocks; revalving is not required but you may adjust damping to suit the new spring rate and vehicle setup.

Will this change ride height or just stiffness?

The wire diameter and free length affect both stiffness and nominal ride height when fitted; expect some change in ride height that can be corrected via preload and shock length adjustment.