HPI Savage 21 Titanium Hinge Pin Upgrade TSAV1101 by GPM  [TSAV1101]

Titanium hinge pins tailored for Savage 21 duty

This kit supplies titanium hinge pins with matching E-clips for the HPI Savage 21, intended as a straightforward replacement for damaged or fatigued stock pins. The components are aimed at hobbyists needing reliable retention at suspension and linkage pivots.

To install, withdraw the old pins from the axle or arm, locate the new titanium pins in the same bore, then lock each one in place with the provided E-clip. Typical handheld tools such as small pliers or an E-clip tool will handle the job quickly.

In practice these pins act as lightweight retention hardware that can tighten up pivot movement and hold alignment under increased stress. Titanium resists corrosion better than standard steel and helps maintain consistent pivot geometry through frequent use.

Fit these as direct swap-in pins to restore secure pivots on HPI Savage 21 rigs or as an upgrade for reduced wear and improved retention.