HPI Savage 29T Replacement Delrin Idler DSAV1229T by GPM  [DSAV1229T]

HPI Savage /Savage Fluorescent x Delrin Idler Gear (29T) - 1pc (Sav) - GPM DSAV1229T
Price:
NZD$16.97
Brand:
GPM
Model:
DSAV1229T
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

29T Delrin idler made for HPI Savage service

This is a 29-tooth Delrin idler intended for HPI Savage vehicles, with a fluorescent surface finish to speed up inspection during servicing. It functions as an RC-scale spare that routes rotation from the motor spur to downstream gears while keeping noise and friction to a minimum.

Built as a direct replacement, the Delrin construction helps reduce gear whine and provides smooth tooth engagement versus some metal alternatives. The bright finish makes it simpler to spot alignment issues or tooth wear during routine checks. Always verify fit and clearance against your gearbox and bearing locations before installation.

Fitting notes: open the gearbox to inspect nearby bearings and locating pins, set proper gear mesh and axial play, and run a controlled low-speed test to confirm engagement. Use this part to maintain drivetrain dependability rather than to increase output performance.

What checks should I do before fitting the idler?

Check the idler tooth count, examine gearbox bearings and shafts for play, and verify there is no interference with the gearbox cover or nearby parts before final assembly.

Does Delrin require special lubrication?

A light application of gear-safe grease on mating faces can reduce wear, but avoid excess to prevent debris buildup; follow your vehicle manufacturer guidance for lubricants.

How often should I inspect the idler?

Inspect during regular maintenance intervals or after any unusual noise or impact; the fluorescent finish helps you see wear early so you can replace the part before drivetrain damage occurs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved