HPI Savage X 8x83mm Dog Bone for Reliable Drive - HPI-86152 by JAZRIDER H  [HPI-86152]

Robust dog bone for Savage X use

This JAZRIDER H HPI-86152 dog bone functions as an RC drivetrain spare intended for HPI Savage X compatibility, provided as 1 pcs in a silver finish. It replaces fatigued drivetrain links and restores consistent power delivery between gearbox outputs and wheel hubs without altering chassis geometry.

Fitting the part is straightforward for anyone familiar with Savage X assemblies: remove the hub or driveshaft retaining pins, slide out the worn dog bone, then install the JAZRIDER H piece making sure it seats properly in the outdrives and hex cups. Confirm clearance at full suspension travel and check retaining clips or set-screws after an initial test run.

In tuning terms, the beefed-up dog bone reduces play at mating surfaces to stabilise throttle response and gives a stronger joint suited to high-stress situations such as aggressive acceleration or rough-terrain running. Use as a direct swap or keep as a field spare.

Notes: perform routine inspection of pin ends and hex interfaces and replace if any deformation is visible. This component is an RC accessory only and not for use on actual vehicles.