HPI Savage Centre gear teeth upgrade TSAV1000 by GPM  [TSAV1000]

HPI Savage /Savage X Titanium Centre Gear Box Teeth With Screws - 5pcs set (29Td, 32Td, 23Td)(37T2Td, 44T1Td) - GPM TSAV1000
Price:
NZD$211.84
Brand:
GPM
Model:
TSAV1000
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Titanium centre teeth for Savage X drivetrains

This aftermarket five-piece teeth kit fits HPI Savage and Savage X scale vehicles and replaces the centre gearbox teeth used in the central drivetrain. The pack includes titanium tooth inserts and matching screws, and the available tooth codes are shown as 29Td, 32Td, 23Td, 37T2Td, 44T1Td; ensure these codes align with your spur and pinion set before you order.

As a direct replacement and tuning component, the titanium option emphasises wear resistance and steady gear mesh under load versus common steel alternatives. It is intended for hobbyists performing gearbox maintenance or incremental tuning where greater gear life and reduced wear to mating parts are desired.

Specifications

  • Item: Titanium centre gear box teeth set with screws, 5 pcs
  • Material: Titanium
  • Model Number: TSAV1000
  • Compatibility: HPI Savage / Savage X

Fit this set when replacing worn centre gears or when changing gear ratios that demand matched tooth counts; double check the listed tooth codes to guarantee correct mesh and clearance.

How do I interpret the tooth codes on the listing?

The codes 29Td, 32Td, 23Td, 37T2Td and 44T1Td indicate the tooth counts and variants. Cross reference these with your current gears to confirm compatibility.

Do I need to modify the gearbox to fit these teeth?

No chassis modifications are intended; the set is a direct replacement form factor, but check screw thread and tooth code match to avoid fit issues.

Will titanium change gear noise or smoothness?

Titanium can maintain tooth profile longer and reduce wear-induced roughness, which helps preserve smooth mesh and predictable noise characteristics over time.

What should I check after fitting these teeth?

After installation confirm backlash and mesh under light rotation, tighten screws to recommended torque and recheck after a short run to verify clearances.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved