HPI Savage Chassis Mounts — Aluminium Front & Rear JR-CHP-SAV-002 by Jazrider  [JR-CHP-SAV-002]

Scale Aluminium Reinforcement Mounts

This front and rear mount pair is produced for the HPI Savage Nitro off-road series and finished in purple anodised aluminium. As a scale accessory the parts replace softer plastic mounting points to deliver improved alignment stability and reduced chassis movement during aggressive running.

Manufactured from aluminium alloy, the mounts aim to balance rigidity with manageable weight to improve durability without excessive mass. They are intended to use the original chassis mounting locations, meaning the swap normally matches factory holes and planes for simple installation and repeatable setup adjustments.

Installation advice: fit the mounts to the stock Savage Nitro mounting positions using existing fasteners where possible, confirm clearances and suspension travel after fitting, and re-check drivetrain alignment. These components are designed for RC models only and are not suitable for full-size use.

With model JR-CHP-SAV-002 you get a straightforward aluminium upgrade path for HPI Savage rigs that increases mounting stiffness while preserving stock geometry for minimal setup disruption.