This alloy front/rear C-Hub is designed for HPI Savage machines and acts as the steering knuckle mounting point in the suspension. It is sold as an aftermarket part to mend broken C-Hubs or renew worn steering linkages without suggesting any official factory origin.
Built from aluminium alloy, the hub works with standard king pins and arrives with the small retaining hardware needed to attach it to steering arms and axle points. Upgrading to alloy hubs often improves alignment stability under load and cuts down on play compared with tired plastic components.
Fitment advice: verify king pin clearance and e-clip fit, tighten fasteners to appropriate snugness consistent with your chassis fasteners, and double-check wheel alignment and toe after installation. Take care not to over-tighten pivot bolts which can cause steering bind.
Use this GPM alloy C-Hub to replace worn front or rear knuckles on supported Savage variants, complete alignment checks after installation, and retain spare king pins and e-clips for ongoing maintenance.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
