HSP 1/10 Crusher BL 2WD Adjustable Rear Knuckle HSP0222WD aluminium upgrade by GPM  [HSP0222WD]

Rear suspension knuckle details

The HSP0222WD rear knuckle arm is an aluminium replacement engineered for the rear suspension on HSP 1/10 Crusher BL 2WD RTR models. It swaps in for the stock knuckle to provide a firmer mounting point for the rear hub and upper tie rod.

By seating the bearing accurately it reduces internal play between hub and axle, and the multiple mounting holes let you set the rear upper tie rods at different positions to tune steering geometry and roll characteristics. Adjusting the tie rod anchor point lets you refine rear toe and steering response without changing leaf springs or shocks.

Forged from 6061 T6 aluminum, the component offers a dependable strength to weight ratio suited to repeated off-road running. Installation is simple for those used to basic RC servicing: remove the hub assembly, fit the replacement knuckle and secure fasteners to recommended torque, then check tracking after a test run.

Fit this knuckle when you need a tougher, adjustable rear hub mount for fine tuning rear toe and improving wheel stability on HSP 1/10 Crusher BL 2WD rigs; confirm alignment after fitting and retighten fasteners after initial running.