HUDY 106001 Drive PIN Removal and Seating Tool - 2.5mm/3mm  [HSP-106001]

Tool for changing 2.5mm and 3mm drive pins

The HUDY 106001 Drive PIN Replacement Tool is a small workshop accessory made to assist removal and installation of 2.5mm and 3mm drive pins on RC models. It is intended to help you extract and seat pins while keeping mating parts aligned.

Engineered for steady handling and consistent results, the tool creates a reliable contact to withdraw worn or misaligned pins and to press new pins squarely into place. The focus is on repeatable seating rather than modifying chassis elements.

To use, position the tip on the pin head or end and apply controlled force to pull the pin or to press in the replacement. Afterwards, verify that the driven component rotates freely and check pin alignment. The tool works without additional adapters when used with common pin profiles.

Keep this tool at your bench or pit box to speed pin swaps and to maintain correct drivetrain alignment, then confirm fit and operation after each service.