HUDY 107880 Lightweight Chassis Balancing Set (2 Pieces)  [HSP-107880]

HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)
Price:
NZD$28.49
Brand:
HUDY
Model:
HSP-107880
Condition:
Brand New
Write a review
alt="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)" title="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)"
alt="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)" title="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)"
alt="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)" title="HUDY 107880 - Chassis Balancing Simple Tool (2 PCS.)"

Fine Tune Chassis Balance for Consistent Handling

Small adjustments to weight distribution can change how your car behaves on corner entry and exit. The HUDY 107880 Chassis Balancing Simple Tool gives a lightweight, durable method to check and refine your setup without guesswork.

Simple Procedure for Accurate Results

Lay the two tool pieces on a perfectly level bench and align the car via the pre-drilled centreline guides. Incrementally add or move ballast until the chassis sits true, then lock in your setup for practice or track day use.

Suitable for a Range of RC Models

This balancing tool suits a variety of vehicle types, from standard touring cars to lightweight club race builds. It is a practical addition to any toolkit for pre-run checks and setup comparisons.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this tool easy to transport to the track?

Yes, the duraluminum construction keeps weight low and the two-piece format packs neatly into a pit box or bag for trackside setup checks.

Can it measure front to rear balance as well as side to side?

By using the centreline alignment and moving weights along the chassis you can assess both lateral and longitudinal balance to refine handling across different track sections.

How should I care for the duraluminum surface?

Wipe the tool clean after use and store it dry. Light corrosion is unlikely but a drop of light oil on mounting surfaces helps if you store it for long periods.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved