HUDY 108041 Upside Measure Plate - Precision 1/8 On-Road Gauge  [HSP-108041]

HUDY 108041 - HUDY Upside Measure Plate For 1/8 On-Road
Price:
NZD$106.31
Brand:
HUDY
Model:
HSP-108041
Condition:
Brand New
Write a review

Set Up Your 1/8 On-Road Car with Accurate Measurements

The HUDY 108041 Upside Measure Plate is a specialist tool for measuring and verifying setup settings on 1/8 on-road RC cars. It supports careful dial-in work, helping drivers tighten handling and maintain consistent lap times through measured adjustments.

Main Benefits

  • Measurement Reliability: Helps you log stable figures for toe, camber and ride height.
  • Durable Design: Engineered to resist wear from frequent use in the workshop.
  • Made for 1/8 On-Road: Geometry and size suit standard 1/8 on-road platforms.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use the plate for both front and rear alignment checks?

Yes. The plate supports measurement of both front and rear suspension settings so you can compare and match geometry across the chassis.

Does the plate require calibration?

No special calibration is needed, but verify the plate is placed on a flat surface and confirm zero references on your car before logging numbers.

What surfaces should I use when measuring?

Use a level, hard surface such as a pit table or concrete floor to avoid false readings caused by uneven ground.

Is the plate compatible with aftermarket wheels and tyres?

In most cases yes, though extreme wheel offsets or tyre profiles may affect contact points. Check that the tyre contacts are repeatable before taking measurements.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved