HUDY 294019 Lightweight Hard-Coat Aluminium Pinion 19T/48  [HSP-294019]

HUDY 294019 Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 19T / 48
Price:
NZD$35.86
Brand:
HUDY
Model:
HSP-294019
Condition:
Brand New
Write a review

Race-Focused Ultra-Light Pinion from HUDY

The HUDY 294019 Aluminium Ultra-Light Pinion Gear is built for pilots who want reduced rotating mass without sacrificing reliability. Its hard-coated surface helps the pinion resist wear while keeping drivetrain friction low for crisper acceleration.

Why Choose the HUDY 294019 Pinion

Crafted from quality aluminium, this pinion balances strength with minimal weight. The hard coating adds protection against abrasion, and the 19T/48 pitch provides straightforward gear ratio adjustment for different track surfaces.

Compatibility and Best Use

Designed to fit a broad range of 1/10 scale models, the pinion is well suited to sprint racing and mixed-surface running. It is a solid pick for racers and tinkerers who want predictable performance lap after lap.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is shaft size important when fitting this pinion?

Yes. Ensure the motor or gearbox shaft diameter and spline type match the pinion. A correct fit prevents slippage and uneven wear.

Does the coating reduce maintenance?

The hard coating helps resist wear, which can lower how often you need to replace the pinion, but regular checks on mesh and lubrication are still recommended.

What setups benefit most from this pinion?

Lightweight, hard-coated pinions like the HUDY 294019 perform well in setups prioritising acceleration and quick throttle response rather than only top speed.

How should I check gear mesh after installation?

Fit the pinion, add a thin smear of gear compound to the spur, rotate the drivetrain, then inspect the contact pattern. Adjust until contact is centered on the tooth face.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved