HUDY 294026 Ultra-Light Aluminum Pinion 26T/48P Hard Coated Race Gear  [HSP-294026]

HUDY 294026 Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 26T / 48
Price:
NZD$37.46
Brand:
HUDY
Model:
HSP-294026
Condition:
Brand New
Write a review

Refine Gear Engagement with the HUDY 294026 Ultra-Light Pinion

RC racers and club drivers can fit the HUDY 294026 Aluminium Ultra-Light Pinion Gear to sharpen drivetrain response. The hard coated aluminium keeps durability high while trimming rotating weight.

Accurate Tooth Profile and Wear Resistance

The hard coating preserves the tooth geometry under load, reducing wear and helping maintain consistent meshing during long sessions on asphalt and carpet.

Balance of Speed and Torque

With 26 teeth on a 48 pitch standard, this pinion is suited to a variety of 1/10 scale rigs where a sensible compromise between top end and acceleration is needed.

Lower Rotational Mass for Better Handling

Dropping a small amount of weight at the motor shaft improves transient acceleration and makes the car feel more responsive through direction changes.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit my 1/10 off-road buggy?

If your buggy uses 48 pitch gearing, the HUDY 294026 26T pinion will fit. Verify motor shaft diameter and set secure grub screw torque when installing.

Should I change spur gear size when swapping to this pinion?

You can alter the spur to tune top speed versus acceleration. Keep overall gear mesh safe and test on a short run to confirm temps and drivetrain behaviour.

Is the hard coat prone to chipping?

The finish is robust, but avoid impacts and contamination. Regular inspection after off-road use will catch any damage early.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved