HUDY 294034 Ultra-Light 34T Aluminium Pinion - Hard Coated - Ref 48  [HSP-294034]

Price:
NZD$37.91
Brand:
HUDY
Model:
HSP-294034
Condition:
Brand New
Write a review

Ultra-light 34T aluminium pinion for motor tuning

The HUDY 294034 pinion is an aluminium R/C gear designed to trim rotating weight while retaining a hard coated surface for wear protection. Marked as ultra-light with 34 teeth and reference 48, it serves as a tuning choice without indicating specific chassis compatibility. Fit it when you want quicker spool-up from electric setups.

In tuning terms, reducing pinion mass decreases rotational inertia, which can improve initial acceleration and throttle feel. Proper gear mesh and alignment with the spur are essential to avoid accelerated wear. Always verify bore fit on the motor shaft and secure the pinion before use.

Specifications

  • Item: Pinion Gear
  • Material: Aluminium
  • Model Number: 294034
  • Teeth: 34T
  • Finish: Hard Coated
  • Reference: 48

Opt for this pinion when you want a low-mass, hard-coated aluminium option for gearing tweaks; check shaft size and mesh before running the model.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What shaft diameters will accept this pinion?

Compatibility depends on your motor's shaft bore and any included set-screw arrangement; confirm the pinion bore matches your shaft or use the correct adapter.

How should I set mesh for best results?

Set a small, even gap between pinion and spur using a spacer or paper method, then tighten the pinion while checking alignment to avoid binding or excessive backlash.

Is a thread locker recommended on the set screw?

A light thread locker can help prevent loosening but use a removable type and avoid over-application to allow future adjustments or removal.

What checks should I do after first fitting?

After fitting, spin the motor by hand to confirm smooth engagement, recheck mesh and secure fastenings, and inspect for any contact points before powering up.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved