HUDY 294157 Ultra-Light Hard Coated Aluminium Pinion Gear 57T 64  [HSP-294157]

HUDY 294157 Aluminium ULTRA-LIGHT Pinion Gear - Hard Coated - 57T / 64
Price:
NZD$46.08
Brand:
HUDY
Model:
HSP-294157
Condition:
Brand New
Write a review

Precision aluminium pinion for tuned drivetrains

For tuners focused on drivetrain tuning, the HUDY 294157 Aluminium Ultra-Light Pinion Gear delivers a compact, well-made option. It is produced from quality aluminium and protected with a hard coat to help resist surface wear during intense running.

Notable traits of the HUDY 294157 pinion

  • Material: Lightweight aluminium construction to lower rotating inertia.
  • Coating: Tough hard-coating to help the gear survive repeated use.
  • Tooth Count: 57T for consistent tooth contact and predictable transfer of torque.
  • Pitch: 64 pitch to match common RC car gearsets.

Specifications

  • Material: Aluminium
  • Tooth Count: 57T
  • Pitch: 64

Suited to experienced hobbyists and club racers who want a reliable, low-mass pinion for improved drivetrain response and longevity.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this pinion suitable for both on-road and off-road 1/10 models?

The 64 pitch 57T pinion suits many on-road and light off-road 1/10 models, though heavy-duty off-road use may call for different materials or thicker profiles depending on impact and grit exposure.

Will the hard coat affect gear mesh setup?

The coating is thin and should not noticeably change mesh, but always set mesh properly and recheck after installation to ensure correct engagement and avoid binding.

Can I balance speed and acceleration by swapping this pinion?

Yes, changing the pinion tooth count is a common way to tune acceleration versus top speed. Use small steps and test runs to find the right balance for your setup.

Any tips for reducing wear when running on dusty tracks?

Fit dust seals where possible, clean gears after each session, and avoid abrasive cleaners. Regular inspection will catch early signs of wear before failure.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved