HUDY 294258 Aluminium Pinion Gear 18T/32 Hard Coated (MODUL 0.8) - Lightweight Performance Pinion  [HSP-294258]

Price:
NZD$42.73
Brand:
HUDY
Model:
HSP-294258
Condition:
Brand New
Write a review

Precision Pinion from HUDY 294258

The HUDY 294258 pinion is a finely machined aluminium part designed to refine drivetrain behaviour. With its hard-coated surface and 18-tooth specification, it delivers repeatable meshing and extended wear life for competitive hobby use.

Strength Without Excess Mass

Engineered for a balance of stiffness and low weight, the HUDY Aluminium Pinion gives dependable torque transfer while keeping rotating mass down. The hard coating helps resist scratches and wear that can occur during aggressive running.

Where It Fits Best

Built to MODUL 0.8 pitch standards, this pinion is compatible with many touring and off-road gearsets, letting builders dial in gear ratio changes for better acceleration or top speed depending on track conditions.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this pinion hold up in mixed surface running?

Yes, the hard-coated finish helps it resist wear from grit and mixed surfaces, though keeping the drivetrain clean will improve longevity.

How do I confirm correct mesh with my spur gear?

Set motor position so the pinion engages the spur with minimal play across the tooth face, then secure and recheck after a short run to allow parts to bed in.

Is aluminium better than steel for pinions?

Aluminium is lighter and can reduce rotating mass, but hard coating and correct maintenance are important to keep wear down compared with steel options.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved