HUDY 990016 Titanium Ball Studs D=5.4mm L=6mm S=4.5mm 2mm HEX Pair  [HSP-990016]

HUDY 990016 - Titanium Ball Stud D=5.4 / L=6 / S=4.5 / 2mm HEX (2)
Price:
NZD$22.28
Brand:
HUDY
Model:
HSP-990016
Condition:
Brand New
Write a review

Fit and Finish with HUDY Titanium Ball Studs

The HUDY 990016 Titanium Ball Studs bring reliable build quality to your RC model, offering long-lasting operation without sacrificing precision. Built from titanium, these studs resist wear and help maintain consistent component alignment during running sessions.

Engineered for Suspension Stability

This two-piece set is specified at 5.4mm diameter, 6mm length and a 4.5mm shaft, which suits a wide range of linkage setups. The 2mm hex socket simplifies removal and refit during setup changes or repairs. Using quality ball studs contributes to steady suspension geometry and improved predictability on different surfaces.

Why Titanium Works Well

Titanium is valued for a favorable strength-to-weight balance, giving toughness without excessive mass. That balance makes HUDY titanium ball studs a good pick for modders wanting dependable, lightweight hardware.
Remark :
Due to limited stock availability, please notice that some HUDY items may have to order from the factory and the ready time is around 8-12 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can these replace standard steel ball studs?

Yes, in many cases titanium studs are direct replacements for steel ones provided thread size and ball dimensions match your model. Always confirm fit before committing to a swap.

Will they save weight on my car?

Titanium typically reduces mass compared to equivalent steel parts, which can help marginally lower unsprung weight; the exact saving depends on the replaced part.

Are there any special care tips for titanium hardware?

Avoid mixing damaged parts into assemblies, keep threads clean, and check for signs of wear or stripped hex sockets. Use the correct 2mm hex driver to avoid damage.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved