Inferno MP Series MP11e Pinion Gear Upgrade 20T 0.8M - Kyosho PNGS0820  [KY-PNGS0820]

Kyosho PNGS0820 - Steel Pinion Gear (20T/0.8M/?5.0)
Price:
NZD$28.61
Brand:
Kyosho
Model:
KY-PNGS0820
GTIN:
4548565456833
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $22.97 each $11.28 or 20%
3+ $21.82 each $20.36 or 24%
Write a review

Why this steel pinion matters

This steel pinion is supplied as Kyosho part PNGS0820 and serves as a straightforward replacement for the motor output gear on compatible Inferno MP Series MP11e cars. It is intended to simplify maintenance and allow precise changes to gear ratios.

The hardened steel construction gives improved wear resistance over softer alternatives, helping tooth geometry remain true under repeated loads. Fit it to replace a worn pinion, test different final drive options, or maintain reliable mesh with your spur gear during tuning sessions.

Installation tips: verify tooth count and module before fitting, slide the gear onto the motor shaft and fix it using your model's original retention method, then spin the drivetrain and check mesh and free rotation to prevent early wear.

Compatibility

  • Inferno MP Series MP11e
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What are the recommended installation steps for PNGS0820?

Start by checking the tooth count and module against your spur. Remove the old pinion, slide PNGS0820 onto the shaft, secure it to the motor using the same method your model uses, and recheck mesh.

How do I confirm bore and shaft seating before fitting?

Measure the pinion bore and compare to your motor shaft. Ensure the pinion seats fully against the motor flange and that any grub screw or collar lines up with the motor shaft flat.

Are special tools required to fit this pinion?

No specialist tools are required beyond the standard hex or screwdriver used by your model for pinion retention. A small file and feeler gauge can help set an accurate mesh.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved