The INFERNO MP10 readyset brings Kyosho race-derived architecture into a ready-to-run 1:8 package fitted with a KE21V .21 engine. The platform is built around a shaft-driven 4WD layout and a chassis intended to preserve suspension geometry under load. This makes it a practical choice for pilots who want authentic hardware without a full assembly process.
The chassis prioritizes structural stiffness in key areas: beefed-up rear shock stays and a reinforced front tower improve load transfer and predictability. Aluminum oil shocks with coil springs are used front and rear to yield repeatable damping across laps and surface changes. The shaft-driven 4WD setup provides steady traction and straightforward driveline maintenance.
Driving the readyset is the KE21V .21 engine with a rear-exit manifold and a polished muffler. A recoil pull starter is fitted for manual starts and a factory break-in ring is already installed to ease the first running period. The power delivery suits the MP10 chassis and its larger tyre fitment.
This unit ships with a complete R/C installation and a waterproof high-torque steering servo chosen for the demands of large buggies. Pre-glued K-Blox style tyres are mounted on the supplied wheels for immediate use on loose and firm surfaces. The body follows the MP10e TKI2 profile and the tray-mounted fuel and engine orientation move mass forward to sharpen turn-in.
The MP10 readyset is aimed at users who want a race-style 1:8 platform without building from parts, and for enthusiasts who favour a rugged, serviceable chassis presented fully assembled.
Kyosho has packaged competitive hardware into a readyset that emphasizes serviceability and track-relevant detail for active model racers and experienced hobbyists.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
