JR-TA110-GU Front Arms for Tamiya TA-01 Aluminum Gun Metal Upgrade by Jazrider  [JR-TA110-GU]

Price:
NZD$16.12
Brand:
JAZRIDER
Model:
JR-TA110-GU
Condition:
Brand New
Available in shop
Write a review

Precision aluminum front arms for TA-01 chassis

These aluminum front suspension arms are built for Tamiya TA-01 chassis use in scale RC cars. The gun metal anodized finish and machined aluminum construction replace plastic arms to offer greater rigidity and longer wear life where a metal option is preferred.

Compatibility: intended for the Tamiya TA-01 platform; check your chassis variant and front arm mounting geometry before purchase. The arms are manufactured to match the standard TA-01 front mounting points and to accept the same linkages and fasteners as the original components.

Installation notes: follow your usual service procedure to remove the factory front arms, retain any pins or screws suitable for reuse, and install the aluminum arms at the factory mounting locations. After installation verify that hinge pins are aligned and suspension travel is free from interference. Readjust toe and camber as required to regain desired handling.

Tuning role: aluminum arms change the compliance of the front end which affects steering feel and body roll. Integrate these arms into a comprehensive setup including springs and shock positions to tune handling for different surfaces.

Maintenance: monitor the anodize and pivot areas for signs of wear, and check hinge pins and mounting interfaces regularly. The aluminum option is robust but can transfer stresses differently than plastic components, so routine inspection is advised.

The gun metal anodize improves surface hardness and corrosion resistance, but check high-contact areas periodically for finish wear and address any bare metal to prevent corrosion.
Aluminum is stiffer than typical plastic arms, which can concentrate load on hinge pins. Inspect pins and bushings more frequently and upgrade to hardened pins if needed.
Regular inspection of mounting holes, pivot interfaces and the anodized surface, plus replacing worn fasteners, will maintain performance and longevity.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved