JR-TASB01-BK Aluminum Front Arms for Stadium Blitzer Range by Jazrider  [JR-TASB01-BK]

Aluminum Front Suspension Arms (Black) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
NZD$25.18
Brand:
JAZRIDER
Model:
JR-TASB01-BK
Condition:
Brand New
Available in shop
Write a review

Front Arm Upgrade Overview and Benefits

This set provides aftermarket aluminum front suspension arms for Blitzer Beetle, Stadium Blitzer and Stadium Thunder platforms. The black anodized finish helps resist wear while offering a stiffer option over stock molded parts for drivers seeking more consistent steering feedback.

Fitment and purpose: the components replicate the original front mounting geometry so they can be used during maintenance or when updating the chassis for improved on-track behaviour. The arms are intended as tuning components to adjust front flex and handling precision.

Fitting tips: where possible reuse existing hardware, verify ball stud and hinge pin alignment, and recheck steering geometry after installation. Run careful tests and adjust progressively rather than making sweeping setup changes.

Tuning notes: alloy arms often work best with modest shock and spring changes and roll center verification to keep cornering balanced as stiffness increases.

Start with small reductions in damping or slight spring rate tweaks and then evaluate cornering balance; monitor roll center behavior and adjust incrementally.
Extra parts are rarely necessary for fitment, but check ball studs and track rods for wear and replace as required to maintain correct toe and steering alignment.
Yes, the consistent stiffness of alloy arms can benefit drivers looking for predictable steering; pair them with careful shock setup and chassis balance tuning.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved