JR-TASB04-LB Light Blue Aluminium Rear Knuckle Arms for Blitzer Beetle / Stadium Thunder by Jazrider  [JR-TASB04-LB]

Aluminum Rear Knuckle Arms (Light Blue) For Blitzer Beetle / Stadium Blitzer / Stadium Thunder
Price:
NZD$18.84
Brand:
JAZRIDER
Model:
JR-TASB04-LB
Condition:
Brand New
Available in shop
Write a review

Durable Light Blue Aluminium Knuckle Arms

These rear knuckle arms are made from light blue anodized aluminium to offer improved long-term durability over the factory plastic pieces. The stiffer material lowers component flex under heavy loads and helps maintain consistent suspension behavior during aggressive driving.

Fitment is limited to the models named: Blitzer Beetle, Stadium Blitzer and Stadium Thunder. Confirm mounting geometry and hole spacing before attempting to fit to any other chassis.

To fit, remove the rear hub carrier assembly and old knuckle arms, note left/right orientation, move over bearings or retainers as needed, then secure the new aluminium arms with the original hardware. After installation, inspect pivot movement and suspension travel and re-check fastener tightness to recommended settings.

Performance note: aluminium knuckles reduce compliance at the rear upright and can stabilise traction under power while making turn-in feel sharper. Integrate these arms into a full setup program including damper and tyre adjustments for best results.

Aluminium resists deformation better than plastic, so you will usually see less permanent wear, but inspect for nicks or burrs after heavy impacts and address any damage promptly.
The anodized surface offers basic corrosion protection, though you should keep pivot areas clean and inspect fastener threads and mating surfaces regularly, especially after wet or sandy use.
Check for play at pivots, ensure fasteners remain tight, and verify bearings are seated correctly to avoid uneven wear or premature failure.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved