This RC-scale C-hub is produced as a direct replacement for the KC10 chassis. It locates the hub carrier with respect to the lower suspension arm and the steering linkage, so precise fitment is essential for steady steering behaviour.
Fitment is limited to KC10 chassis units, so confirm your chassis code prior to purchase. The item restores correct steering geometry after wear or collision damage and provides a stable platform when making tuning adjustments.
Installation tips: remove the wheel and hub carrier, check mounting screws and bushings, move any usable sealed bearings or shims across, and reinstall using the original mounting points to preserve suspension geometry. Use your normal KC10 torque and thread-lock routine to avoid inducing alignment errors.
Tuning notes: installing a fresh C-hub can correct toe and steering response affected by a worn part, making it a recommended service spare for pre-event maintenance. It is a service replacement rather than an aftermarket performance mod.
Keep a spare C-hub available to shorten repair times during meetups and to maintain consistent KC10 setup between runs.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
