KC10 Front Axle Shaft Compatible with Kyosho CL022 (1pc)  [KY-CL022]

Front drivetrain shaft for KC10 chassis

This Kyosho CL022 front shaft is an RC-scale replacement designed for the KC10 chassis, delivered as one piece for the listed front location (KC10/L/R). It is intended to reinstate the front drivetrain and steering linkage without changing the chassis geometry.

Fitment and role: the component aligns with KC10 mounting points and replaces the original shaft within the same bearings and retainers. Use it for scheduled maintenance, to correct wear, or to replace a shaft bent or broken in an impact.

Installation notes: follow the KC10 service routine by removing the wheel and any hub halves, slide the shaft through the front drivetrain carriers, then secure using the original screws and retainers. Verify the driven parts rotate freely and remain aligned before refitting the wheel to avoid binding.

Tuning considerations: fitting a fresh shaft reduces steering play and helps preserve predictable handling, which supports consistent setup results. After fitting, check toe and camber under static load and run a short test to confirm on-track behavior.