KC10 Replacement Wheel Hub CL019 (4pcs) - Kyosho  [KY-CL019]

Overview and fit for KC10

The Kyosho CL019 wheel hubs are supplied as a 4pcs replacement set designed for the KC10 chassis, intended to keep wheel mounting secure and to simplify routine upkeep. This summary covers how the hubs affect fit and handling and what to check before fitting.

Compatibility: built for the KC10 chassis family, the set keeps wheel fitment matched across an axle. Always check hub geometry and wheel hex dimensions prior to installation to confirm clearance and alignment.

Installation notes: start by removing the wheel and existing hub, inspect the axle and wheel hex for wear, press or seat the CL019 hub correctly and tighten retaining hardware to the recommended feel, then verify free rotation without binding. Recheck wheel offset and track width after assembly to preserve handling balance.

• Tip: Keep original wheel hexes and fasteners where possible to maintain factory offset unless altering track width is intended.
• Tip: Check wheel bearings for roughness or play when replacing hubs to avoid concealing bearing faults.
• Tip: Run the model briefly after fitting and inspect fastener torque and wheel runout again.

Compatibility

• KC10 chassis

Store a set of CL019 hubs as spares to quickly restore correct wheel mounting on KC10 models and to maintain consistent handling between track sessions.