KO Propo 35035 RSx3 Upper Case Maintenance Panel  [KO-35035]

KO Propo 35035 - RSx3 Upper Case
Price:
NZD$13.63
Brand:
KO Propo
Model:
KO-35035
Condition:
Brand New
Write a review

Keep Your Servo Running Smooth with KO Propo 35035 RSx3 Upper Case

Enthusiasts who take care of their kit know small parts matter. The KO Propo 35035 RSx3 Upper Case is a replacement shell that helps prevent dust and small debris from reaching gears and electronics, aiding long term reliability.

Where It Fits

The RSx3 upper case is compatible with a number of KO Propo servo models and suits hobbyists who service their gear regularly. The design allows a snug fit so the internal assembly stays secure during use.

Simple Swap Instructions

Before fitting the new case, clean the cavity and check gear mesh. Tighten screws in a cross pattern to keep the case sitting true and avoid any binding in the control linkages.
Remark :
Due to limited stock availability, please notice that some KO Propo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How hard is it to replace the upper case on an RSx3 servo?

Swapping the upper case is a low skill job for most modelers. Remove the top screws, clean the internals, then fit the new case and secure the screws evenly.

Should I inspect gears while the case is off?

Yes. Use the opportunity to check for wear on plastic or metal gears and replace worn parts to prevent failure during a run.

Is any special tool needed to fit this part?

Standard precision screwdrivers are sufficient. Avoid over tightening and use threadlocker only if you typically experience screw backing out.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved