KO Propo 35546 High-Precision Aluminium Gear for BSx2 Servo  [KO-35546]

KO Propo 35546 - Aluminum Gear for BSx2 Response
Price:
NZD$50.09
Brand:
KO Propo
Model:
KO-35546
Condition:
Brand New
Write a review

Precision Replacement Gear for BSx2 Response Servos

The KO Propo 35546 aluminium gear is crafted as a direct replacement for the BSx2 Response servo line. Designed with longevity and smooth meshing in mind, it helps reduce play and improve control fidelity in both on-road and off-road models. Using aluminium instead of standard materials gives better wear resistance and a more consistent feel over time.

Why Switch to an Aluminium Gear

Aluminium delivers a good balance of strength and low mass, which benefits high-performance setups. The KO Propo 35546 enhances gear stability and precision, helping the servo translate input into accurate movements with less backlash. It is suitable for modelers who expect repeatable steering and reliable control during demanding sessions.

Installation Notes and Compatibility

This part is made to fit the BSx2 Response series without modification, allowing a straightforward swap. As an OEM-compatible component for KO Propo servos, it minimises the effort needed to replace worn gears and gets your model operational again quickly.
Remark :
Due to limited stock availability, please notice that some KO Propo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use KO Propo 35546 in a high-torque servo?

The gear is intended for the BSx2 Response series. If your servo shares the same gear interface and can handle metal gears, the aluminium part will hold up better than stock plastic under higher loads.

Will this change servo feel or centring?

Upgrading to a metal gear can tighten backlash and make responses crisper. Proper installation and correct mesh are important to preserve accurate centring and smooth operation.

Any special tools required to fit the gear?

No specialised tools are required beyond basic servo service tools. Take care with screws and washers and verify gear mesh when reassembling to avoid premature wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved