Kyosho 74033-12 KE15SP Back Plate for FW06 Models  [KY-74033-12]

Kyosho 74033-12 - Back Plate Set (KE15SP)
Price:
NZD$40.10
Brand:
Kyosho
Model:
KY-74033-12
Condition:
Brand New
Write a review

Back Plate Guide for Kyosho 74033-12

The Kyosho 74033-12 Back Plate Set is built to integrate with KE15SP engines and the FW06 series. It supports a firm seal at the engine rear to help maintain steady running under varying conditions.

Compatibility with KE15SP

This back plate is matched to the KE15SP rear mounting and sealing surfaces, allowing it to sit flush with the FW06 chassis components. Correct fit prevents unwanted leaks that can alter combustion and engine response.

Simple Installation Steps

Before fitting, remove old gasket residue and check the plate and crankcase faces for burrs. Start bolts by hand to ensure alignment, then tighten progressively. The procedure is straightforward and suitable for most model tuners.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
The design targets the FW06 chassis and KE15SP engine layout. Other chassis may not line up with the mounting holes, so measure before buying.
The back plate itself preserves the factory sealing surface. If fitted correctly it should maintain existing performance rather than boost power.
Basic hand tools are sufficient, such as small hex drivers and a torque-friendly driver for final tightening. Clean rags and a brush help prepare surfaces.
Start the engine and listen for irregular idle or hesitation under throttle. If you suspect a leak, recheck alignment and gasket condition and repeat the sealing steps.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved