Kyosho BRG031 Shield Bearing Pair 5x11x4mm  [KY-BRG031]

Kyosho BRG031 - Shield Bearing (5x11x4/2Pcs)
Price:
NZD$21.71
Brand:
Kyosho
Model:
KY-BRG031
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Dependable Kyosho BRG031 Shield Bearings

The Kyosho BRG031 shield bearings are built to help keep rotating components running true in a range of RC kits. Sized at 5x11x4mm, this two-piece set fits many common hubs and shafts used across models.

Designed for Consistent Rolling

Delivered as a matched pair, these shield bearings reduce friction and provide steady support for spinning parts. Their sealed faces help guard against light contamination, which supports longer service life between maintenance sessions.

Typical Use Cases for Hobbyists

Whether trimming lap times or enjoying a casual session, the Kyosho BRG031 bearings are suited to areas where precision turning and reduced wear are important. Keep a set in your spares box for quick replacements.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will the BRG031 fit older vintage models?

Compatibility depends on the original part size. If the original bearing or bore matches 5x11x4mm, the BRG031 should fit, but verify measurements before fitting.

Are these sealed bearings waterproof?

They are shielded to keep out dirt and light moisture, but they are not fully waterproof. Avoid prolonged immersion or heavy water exposure for best results.

Can I upgrade these bearings to ceramic?

If your hub supports the same dimensions, you can swap to ceramic or higher-end bearings. Make sure the tolerances and clearances are compatible to avoid binding.

How do I clean a shield bearing without removing the shields?

Use a solvent spray applied briefly while spinning the bearing to flush contaminants, then apply light bearing oil. If contaminants persist, consider removing the shields or replacing the bearing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved