The Kyosho CLB002WG decoration body set is intended for RC-scale cosmetic enhancement and is tailored to chassis that use the KC10 mounting pattern. The write-up focuses on ensuring proper fitment, alignment of body posts, and practical trimming guidance for neat results.
Compatibility and fitment: designed around KC10 post layouts, the shell requires verification of post positions, roof fittings and wheel/tire clearance before permanent mounting. Make small progressive trims to arches or mounting holes and test the fit often to prevent over-cutting.
Installation notes: align and mark post holes while sitting the shell on your chassis, then use existing posts and clips where feasible. Trim from the inner surface and use light tools to retain control over cut edges. Fasten the shell with standard body clips or compatible aftermarket hardware, confirming there is no interference with suspension articulation or steering travel.
Tuning and use: this Type2 decoration is mainly for looks and scale authenticity. Any changes to airflow or mass are typically slight, so adjustments to handling are usually unnecessary beyond securing the body properly to avoid noise or contact while running.
For scale builders using KC10-style rigs, the CLB002WG Type2 decoration shell provides an authentic Land Cruiser 60 aesthetic with straightforward installation steps and minimal tuning tradeoffs.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
