Kyosho Compatible Delrin Motor Gears 13T/14T DKM135 by GPM  [DKM135]

Kyosho Motor Cycle Delrin Motor Gear (13T, 14T) - 2pcs set - GPM DKM135
Price:
NZD$6.53
Brand:
GPM
Model:
DKM135
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Delrin pinions for Kyosho motorcycle applications

This product is a 2pcs set of Delrin motor gears in 13T and 14T designed for use in Kyosho motorcycle kits. Delrin pinions are chosen for lower friction and a quieter mesh on light load electric setups compared with some engineering plastics.

Fit these DKM135 pinions when you want to tweak pinion tooth count for small ratio changes or to replace a worn plastic pinion. Delrin provides a compromise between stability and wear resistance suitable for normal RC motor outputs and lets you adjust gearing without changing the spur gear.

Installation tips: remove the motor per your model instructions, fit the selected Delrin pinion onto the motor shaft using the existing retention method, set mesh and axial alignment, then rotate freely to confirm clearance before reassembly. Check the motor shaft and fasteners for any signs of wear prior to running.

Does the set include both sizes?

Yes, the kit includes two Delrin motor gears: one 13 tooth and one 14 tooth unit, packaged as a 2 piece set for testing or replacement.

Are these suitable for high RPM motors?

Delrin is suitable for moderate motor RPMs and light loads; for sustained high RPM or heavy torque use consider monitoring wear more frequently.

What should I check after fitting?

After fitting, verify correct mesh, ensure the pinion is seated and secure, then run a low speed test to confirm clearance and no binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved