Kyosho FAW318 Turnbuckle Rod Kit for Fazer D2 Adjustable Steering and Rear Links  [KY-FAW318]

Precision Rods for Fazer D2

The Kyosho FAW318 turnbuckle rod set is an aftermarket accessory tailored to the Fazer D2 on-road drift chassis. It supplies adjustable aluminum steering and rear upper rods intended to replace softer plastic parts, improving steering consistency and making fine trim adjustments easier during setup.

Crafted from A7075 aluminum with a red anodized finish, these rods add torsional stiffness versus stock plastic linkages. The firmer connection helps translate servo motion more directly to the steering knuckles and improves rear upper link stability during controlled slides and precision runs.

Designed specifically for Fazer D2 fitment. The set contains the servo linkage rod and rear upper turnbuckles; if your car has custom modifications, verify the linkage geometry prior to installation to ensure proper fit.

Installation guidance: align rod ends and hand-thread components first, then lock to the recommended specification. Use a small amount of thread-lock where steel fasteners engage aluminum and confirm that ball cups move freely without binding. Adjust in small increments and re-evaluate handling after each change.

Service advice: inspect anodized surfaces after impacts and replace any bent item instead of attempting to reshape it, as straightening can reduce structural life. Monitor rod-end wear and tighten connections periodically for consistent setup.

FAW318 delivers a straightforward aluminum upgrade for Fazer D2 linkage points, offering a durable base for steering and rear toe refinement.